Enerscope Systems Inc.

Produced Water Treatment

Produced Water TreatmentUnits designed for installation prior to FWKO and heater Treater. Remove unwanted solids and increase production without causing emulsions. Desanders installed have decreased maintenance by an average 400%. 

System Identification:
Oil production; produced water; protection of FWKO and Heater-Treater

Sand, silt, clay and hydrocarbons in oil/water emulsion

At the Renaissance Energy site in southwest Saskatchewan, a high level of sand in the Free Water Knock Out (FWKO) tank and heater-treater tank was causing the plant to shut down for maintenance every 4-5 months. The produced water contains an oil/water emulsion mixed with sand, clay, silt and hydrocarbons. The sand was filling up in the tanks, leading to lower efficiencies, and inadequate retention time in the heater-treater. Renaissance had previously tried another type of separator, but was unhappy with the performance and durability of the unit.


An Enerscope Desander was installed prior to the FWKO to remove the unwanted sand, silt and clay. Production Engineer Mike Briffett found that not only were the tanks protected, maintenance time was reduced significantly. This helped to lower maintenance costs and eliminate the previous plant shutdowns, thereby increasing production, resulting in cost savings exceeding $200,000 at this site alone. With the desander in place, shutdowns are limited to a required annual inspection. Additionally, the consistent low pressure drop of the Enerscope Desander, maintains a consistent flow in the battery. Briffett also noted the ease of installation and the compact profile of the desander. The system has been in operation at the Verlo Battery for more than four years and Renaissance is pleased with the performance, finding the Enerscope Desander an effective method for removing sand from produced water. An additional ten units have been purchased for installation in various production sites.

Typical Treating Facility


Tell a FriendRequest Information